I need some beehive springs and retainers
setup for at least a .550 lift using 5 inch valves.thought I would post here as manywont read it in classifieds
View ArticleRe: I need some beehive springs and retainers
For which head casting #? What do you want in the way of seat and open pressure(s)? Are you using Viton seals?Are you willing to machine the guide?
View ArticleRe: I need some beehive springs and retainers
67 4 bbl castingI machine all my heads for guide seals.seat pressures around 250 maybe alittle moreWhy would I need to machine the guide?
View ArticleRe: I need some beehive springs and retainers
Some of the beehive springs we're playin' with have a smaller ID than the factory springs. They're a little lighter than most, that's all. Are you sure you want a seat pressure of 250? That sounds a...
View ArticleRe: I need some beehive springs and retainers
oops yepseat pressure around 100 maybe a little higher
View ArticleRe: I need some beehive springs and retainers
That sounds exactly like the springs we're using on a head we're setting up right now. I'll get the P/N's from the machine shop for both the springs and retainers. I'll also be able to provide the...
View ArticleRe: I need some beehive springs and retainers
Factory height is 1.586 for the 5 inch valveBut since the retainer has changed it may not be same heightIf I remember right I got coil bind with .550 lift and stock retainers and springs.I never was...
View ArticleRe: I need some beehive springs and retainers
I know this is five years old, but any more info on possible Beehive springs? I'm thinking I'll be replacing the valves, and likely the springs on my engine and would like to see about being able to...
View Article
More Pages to Explore .....